CHERYLAS- varicose vein
EVLA treatment
The
procedures are generally performed on an ambulatory basis with local anesthetic
and typically require no edation. The patients are fully ambulatory following
treatment, and the recovery time is short. In this article.
EVLA mechanism of
action
The
underlying goal for all thermal ablation procedures is to deliver sufficient
thermal energy to the wall of an incompetent vein segment to produce
irreversible occlusion, fibrosis, and ultimately disappearance of the vein. The
mechanism of vein wall injury after EVLA is controversial. It has been
postulated to be mediated both by direct effect and indirectly via
laser-induced steam generated by the heating of small amounts of blood within
the vein. Adequately damaging the vein wall with thermal energy is imperative
to obtain effective ablation. Some heating may occur by direct absorption of
photon energy (radiation) by the vein wall, as well as by convection from steam
bubbles and conduction from heated blood. However, these later mechanisms are
unlikely to account for most of the impact on the vein.
Diode lasers
advantage
Diode
lasers are most commonly used for EVLA. Laser generators exist with multiple
different wavelengths, including lower wavelengths that are considered
hemoglobin specific and include 810 nm, 940 nm, 980 nm, and 1064 nm. Higher
wavelengths are considered water specific and include 1320 nm and 1470 nm.
Although it is still not definitively established in the literature, some
authors suggest that the higher wavelength lasers produce similar efficacy at
lower power settings with less postprocedure symptoms.
Accessory
It
can be performed with multiple different laser fiber designs (ie, bare-tip
fibers, jacket-tip fibers radial fibers) and diameters available from a variety
of vendors. Each of the fiber designs has been demonstrated to be effective in
closing the saphenous vein.Specifications
Laser Name
|
CHERYLAS
|
Laser Type
|
GaAlAs Diode Laser
|
Wavelength
|
810nm/ 940nm/ 980nm/ 1470nm
|
Maximum Power
|
15W/ 30W/ 60W
|
Operation Mode
|
CW, Single Or Repeat Pulse
|
Pulse Duration
|
10us- 3s
|
Repetition Rate
|
0.2Hz- 50KHz
|
Pilot Beam
|
Red Diode Laser Of 650nm, Power<5mW
|
Control Mode
|
True Color Touch Screen
|
Transmission System
|
Medical Fibers With SMA905 Connector
|
Dimensions
|
380(W)*430(L)*220(H) mm
|
Weight
|
11Kg
|
Comments
Post a Comment